Diamond Authentication Check at Home
10.10.20 0 Comments
A diamond is a polished and cut diamond. Diamond is one of the most expensive stones used in jewelry making. Please note that you should not buy diamond jewelry without first checking for authenticity. But in case you have already purchased a diamond jewelry piece or you have received it, we will give you some simple ways to determine the quality and authenticity of the diamond at home. Diamond Authentication Testing at Home Diamond inspection with a magnifying glass Visual inspection First of all, you should examine the diamond with a magnifying glass very carefully. A true diamond, even of the highest quality, will always have the tiniest recesses of other elements or tiny internal flaws. These can be light or dark dots, as well as minor cracks and strips. The cost of absolutely pure diamonds is simply cosmic and they are extremely rare. So, if you bought a jewelry piece with perfectly clean diamonds at a quite reasonable price, the diamonds in it are likely to be fake. Diamond is the hardest mineral in the world, so once processed, its edges become very smooth and clear, which also means its authenticity. Shabby edges with rounded edges will indicate that it is glass. It is also possible to check the rune of a diamond. The rundist is called a narrow band boundary that separates the crown (top) and pavilion (bottom) of the cut stone. The rundist must be slightly matte and rough. Be sure to pay attention to the brilliance of the diamante. A direct electric light may be directed at the diamond. A true diamond, unlike fakes, will not shine with all the colors of the rainbow, but only a few shades of gray, and it will sparkle not only from above, but from all sides. To check the diamond for authenticity, you should bring the diamond piece to a bright light source and watch the beam that will pass through it. If you look at the stone from above, you will see a lot of shades and a small light point in the center of the stone. This will testify to the authenticity of the diamond. It should be remembered that the most accurate and reliable way to look at a diamond is to look at it without setting. Diamond Authentication Tips There are many ways to authenticate a diamond at home. Let's consider the simplest and most effective of them: The easiest way to verify the authenticity of a diamond from all existing ones. Just take a breath on the stone and see if it will mist. Unlike fakes, a real diamond will instantly dissipate all the heat of your breath, so the diamond surface will remain transparent and clean. Checking the diamond with warmth. Under the influence of the warmth of the human body, the real diamond will warm up for a long time. So to check the authenticity of the diamond at home, you just need to hold it in your palm for a few minutes. You will feel the cold of the real diamond for a long time. Checking the diamond with sandpaper. You should rub the diamond with sandpaper, then examine its surface. The diamond has a higher density than sapphire, which is a part of sandpaper, so if there are any scratches or scars on the stone, you will see a fake stone. The original diamond will not tolerate any changes when rubbing. But be careful that the composition of sandpaper was not a diamond crumb - such a test can spoil a diamond even the highest quality. Checking the setting. In making jewelry out of cheap metals, no jeweler will use genuine gemstones. Noble diamonds are in harmony only with expensive metals like gold or platinum. Testing a diamond for authenticity with water. You can determine the authenticity of a diamond by placing the diamond jewelry or the stone itself in a water container. Because of its transparency, the diamonds will be almost invisible in the water, but only the rudder, defects and embeddings on the mineral will be visible. Ultraviolet inspection of a diamond. Under the influence of ultraviolet rays, an original diamond will cast a bright blue hue and sparkle strongly. A fake diamond will acquire a greenish yellow light and will reflect only a few reflections. These simple methods of checking the diamond for authenticity will allow you to independently verify the quality of your jewelry. If, however, you still have any doubts after the checks, then we recommend you to contact a special laboratory. The use of specialized equipment and modern technologies will allow you to determine the authenticity of the diamond with accuracy. There are 3 common myths about diamonds. Diamonds are very often assigned special qualities that are not typical of them. That is why some people use completely wrong methods to check the diamonds for authenticity. Incorrect manipulations can irrevocably spoil the diamonds, so we recommend you to read the information below carefully. It is impossible to break a diamond. There is a myth that due to its high density, diamonds can easily withstand the impact of a hammer. Never use this method in practice, because the diamond will break into small pieces. A real diamond is completely invisible to the water. Because of the different density of liquid and mineral, even the best quality diamond will be visible in water. In the water, you can see the junction of the upper and lower parts of the product, as well as the embedding of other elements. Russian diamonds are of higher quality than "foreign" diamonds. The place of origin of the diamond does not affect its quality at all. For example, if you compare the "Canadian" and "Yakut" diamantaires, which have the same quality and color characteristics, they will be absolutely identical. Keep in mind that only a professional gemologist, a specialist in the study of gemstones, their composition and origin, can determine the diamond's authenticity with 100% accuracy.
How to check a diamond for authenticity at home